8, clean moisture separator moisture separator structure similar to the oil and gas tanks, air intake against the wall design, so the formation of a centrifugal force, the weight factor due to water and gas, compressed air can be effectively separated in the water. Moisture separator cleaning: open the moisture separator cover, you can use detergent immersion cleaning. 9, correcting all the parameters of all the above components and dry after cleaning the air compressor to start the installation, all components attached to the compressor should again check for omissions and clean during installation tools and other items used. Wash load reduction valve (inlet valve) bis (1) Cleaning: as intake valves dirt more serious, then replace it with a new cleaning cleaning agent, the cleaning process to wash the dirt should be washed after much cleaner parts parts. Cleaned parts rinsed again with fresh water to prevent corrosion and shorten the service life of components, the components washed with water should be placed in a clean dry place to avoid iron rusting parts. Should purge valve and place the body in contact with the valve in note smoothness of the surface, and should be cleaned, replace it if necessary, otherwise it will cause will have when the compressor can not start with a load (a large plant with a load start start phenomenon). (2) Installation components: Component installation removed anti-press steps. Should make is when you install components, component location and activity of installed seals should be coated with an appropriate amount of oil can install seals better, more flexible moving parts. Note: Due to the unloader valve more parts, if not sure to remember the location of each part can be cleaned after each split a component mounted on the part of air compressor manufacturers offer, but members do not install to the body, All parts are cleaned and then be assembled together to the valve body. (3) unloader valve aside to complete the cleaning process to be loaded into the compressor. Saturated compressed air first enters the higher temperature refrigeration dryer pre-cooled air compressor manufacturer in the precooler and evaporator from a local dry cool air compressor manufacturer direct heat exchange, the temperature has been initially reduced After entering the evaporator, the compressed air in the evaporator in heat exchange with a second refrigerant vapor, the temperature was further reduced to close to the refrigerant evaporation temperature; in the two cooling process, the compressed air saturated water vapor to condense into liquid water droplets into the air and the gas-water separator compressor manufacturer rankings, separator to separate liquid water through automatic drain (not shown) from the plane, the lower temperature of the drying air is returned to the pre-cooling device, and just entering the saturated air heat exchange, so that the temperature itself is improved, resulting in cold and dry vents get a lower water content (ie, lower dew point) at the same time lower the relative humidity of the drying air. From the above analysis shows, pre-cooling, evaporator and air-water separator is cold and dry compressed air flow system of hollow three major components. Air compressor manufacturers build, Qin Wei Air (certified), Weicheng compressor manufacturers to provide the Compressor Co., Ltd. Xianyang Qin Wei. Xianyang Qin Wei Compressor Co. (www.xykyj.cn/) is Xianyang, compression, separation equipment leader, over the years, the company implement the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Qin Wei Pneumatic leadership with the staff warmly welcome all inquiries negotiations to create Qin Wei Pneumatic better future.